Ineos Grenadier Custom Logo Stickers - Hood & Tailgate - A Shaped

This custom hood and tailgate logo sticker kit is designed specifically for the 2023-2026 Ineos Grenadier Station Wagon. Digitally cut to match the exact factory specifications, the components integrate into the stamped lettering indentations on the front bonnet and rear door. By utilizing the factory stamping as a native physical alignment guide, this product fills the bare metal stamped areas without requiring permanent vehicle alterations. The non-destructive installation process preserves the factory paint clear coat from environmental degradation and minor abrasions, maintaining original vehicle condition and secondary market resale value.

Key Features:

• Exact Factory Fit: Digitally cut to match the stamped lettering indentations on the front bonnet and rear door of the 2023-2026 Ineos Grenadier Station Wagon.
• Paint-Safe Adhesive: Pressure-sensitive adhesive with low initial tack for repositioning, transitioning to high bond strength upon final compression. Removes cleanly without residue.
• UV-Resistant Coating: Multi-layer glossy coating resists color fading under prolonged solar exposure.
• Weatherproof: Rated to withstand high-pressure wash systems up to 150 bar, mud, rain, and off-road debris.
• Tool-Free Installation: Self-adhesive with integrated transparent transfer tape. Estimated installation time 20 minutes.
• Non-Destructive: Entirely external, no drilling or cutting required.

Technical and mechanical specifications: The substrate consists of a 0.12mm high-grade automotive cast PVC vinyl film, selected for high three-dimensional conformability. The face film features a protective multi-layer glossy UV-resistant coating that resists color fading and material degradation under prolonged solar exposure. The reverse side utilizes a specialized pressure-sensitive adhesive system engineered with low initial tack to facilitate positioning, transitioning to high ultimate bond strength upon final compression.

This product requires a dry application method. The use of water, soap solutions, or application fluids is not recommended. The installation utilizes the integrated transparent transfer tape as a physical alignment carrier. The pressure-sensitive adhesive provides low initial adhesion upon contact, allowing a single operator to lift and reposition the film repeatedly in a standard garage environment without causing physical material elongation or distortion. Once alignment with the factory stamped groove is verified, firm physical pressure applied via fingers or a squeegee consolidates the adhesive layer, achieving maximum surface contact and establishing the permanent high-strength bond. Estimated installation time is 20 minutes for a single operator. This modification is entirely external and non-intrusive to vehicle systems.

Q: Will removing these stickers damage the factory vehicle paint or leave adhesive residue behind?
A: The automotive-grade pressure-sensitive adhesive features high internal cohesion. Upon removal at the end of the service life, the adhesive layer detaches completely with the PVC substrate, leaving zero chemical residue on the paint surface and fully protecting the factory clear coat.

Q: Can the vehicle be washed with a high-pressure power washer after installation?
A: High-pressure washing is safe once the adhesive reaches full cure after 24 hours. The bond strength withstands standard commercial pressure washers rated up to 150 bar without inducing lifting or edge peeling.

Q: Why must this product be installed using a dry application method instead of using application fluid?
A: The pressure-sensitive adhesive layer is designed to bond directly to dry paint surfaces. Introducing water or wetting agents traps liquid under the film substrate, which disrupts the chemical curing process of the low-tack adhesive and leads to long-term adhesion failure or bubbling.