INEOS Grenadier & Quartermaster LED Puddle Lights: Plug-and-Play Installation Guide

Upgrade the factory lower door courtesy lamps on 2023-2026 INEOS Grenadier Station Wagon and Quartermaster models with focused ground projection modules. Each set includes 2 plug-in LED lights for two doors and installs in 5 to 10 minutes per door without wire splicing.

Nov 18, 2026
THE 30-SECOND DECISION

Buy it if: You own a 2023-2026 INEOS Grenadier Station Wagon or Quartermaster (LHD or RHD) and want focused downward ground projection that plugs directly into the factory lower door wiring harness without cutting wires. Each set includes 2 modules (covering two doors), so order 2 sets for full four-door coverage.

Skip it if: You are looking for wide-beam rock lights mounted under the chassis frame or an interior footwell ambient strip rather than a direct lower door courtesy lamp replacement.

Stepping out of an INEOS Grenadier at night on unlit gravel trails, wet pavement, or muddy campsites often leaves the ground directly beneath the door sill poorly illuminated. While the factory lower door courtesy lamp (the small light mounted at the bottom edge of the door panel) turns on when the door opens, its diffused white beam spreads thin and fails to define puddles, sharp rocks, or uneven terrain.

Replacing those stock housings with compatible INEOS Grenadier LED puddle lights solves this visibility gap in 5 to 10 minutes per door. Because the modules match the factory door opening and electrical plug on both left-hand drive and right-hand drive builds, you keep the original wiring harness intact and can revert to stock parts at any time.

INSTALL TIME
5-10 MIN/DOOR
WIRING
PLUG-IN
PACKAGE QTY
2 PCS (1 PAIR)
FITMENT
2023-2026

Factory Courtesy Lamps vs. Focused Ground Projection

Every 2023-2026 INEOS Grenadier Station Wagon and Quartermaster leaves the factory with lower door courtesy lamps recessed into the bottom trim of the doors. Understanding how the stock assembly differs from an optical projection module helps clarify what changes after the swap.

01 / OPTICAL DESIGN
Focused Lens Projection

Replaces broad, low-contrast scattered light with a concentrated downward optical beam that highlights the immediate step-out zone.

02 / CIRCUIT INTEGRITY
Zero-Splice Plug Connection

Connects directly to the existing factory wiring harness plug inside the door cavity with no wire stripping, tapping, or adapter harnesses.

03 / CHASSIS PARITY
Wagon & Quartermaster Fit

Both body styles share identical lower door lamp cutouts and electrical connectors across front and rear passenger doors.

Parameter / Dimension Factory Courtesy Lamp STREK LED Puddle Light
Light Source & Optics Diffused white lens without beam shaping Focused LED projection lens with crisp pattern edges
Ground Visibility Soft ambient glow; low contrast on dark gravel or mud High-contrast vertical illumination over the door entry area
Wiring Connection Factory door harness plug Direct plug-in to factory door harness (zero cutting)
Pattern Options Plain white illumination only 7 vehicle-specific patterns (A-G) plus custom etching (H)
Side-by-side comparison showing the diffused white beam of the factory lower door courtesy lamp on the left versus the focused Pattern A ground projection of the STREK LED puddle lights on an INEOS Grenadier on the right.
Figure 1: Side-by-side comparison showing the diffused stock door lamp output (Before) versus the focused ground projection from the STREK LED module (After).

Vehicle Fitment, Package Quantity, and Pattern Selection

Before placing an order, verify both the number of doors you plan to upgrade and the model-specific graphic pattern designed for your vehicle body style. While the physical housing and connector fit all four doors on both the 2023-2026 Station Wagon and Quartermaster pickup, the graphics are split by model name.

The Expensive Mistake:

Each set includes only 2 LED puddle lights (1 pair), which fits 2 doors (either the front pair or the rear pair) and cannot cover all 4 doors. If you want to upgrade all 4 doors on a Station Wagon or Quartermaster, you must order 2 sets (4 lights total). Also verify the pattern code before checkout so Quartermaster owners do not order Station Wagon graphics by mistake.

Pattern Code Intended Vehicle Graphic Description Price (2 PCS)
Patterns A - F INEOS Grenadier Station Wagon (2023-2026) 6 Grenadier designs (vehicle profile, red A, white lettering, Built for More, side silhouette, framed red A) $149.00
Pattern G INEOS Grenadier Quartermaster (2023-2026) Quartermaster pickup graphic with red letter A accent $149.00
Pattern H (Custom) Station Wagon & Quartermaster (2023-2026) Custom etched lens; email high-resolution vector artwork to sales@strekoffroad.com after ordering $199.00
Grid displaying all eight projection options for STREK LED puddle lights, including Patterns A through F for the INEOS Grenadier Station Wagon, Pattern G for the Quartermaster pickup, and Pattern H for custom artwork.
Figure 2: Visual reference for Patterns A through F (Grenadier Station Wagon), Pattern G (Quartermaster pickup), and Pattern H (custom etched lens).

The Hardware Boundary: What Is Included and What Is Not

Planning a clean installation starts with knowing exactly what arrives in the box and what basic hand tool you need on hand. Review the component scope below before starting work on your doors:

Component Category Included in Kit (Per Set) Buyer Responsibility
LED Puddle Light Modules 2 PCS LED projection assemblies with integrated factory-style sockets Order 2 sets (4 PCS total) if replacing all four doors
Removal Tooling & Artwork Pre-installed optical lens matching selected pattern (A-H) Plastic trim pry tool (or flat-blade screwdriver wrapped in electrical tape); vector file for Pattern H

3D Installation Overview and Step-by-Step Replacement

The entire swap rates at a 1 out of 5 difficulty level and takes 5 to 10 minutes per door. Watch the 35-second overview below to see the lower door lamp recess, connector release tab, and seating angle before starting.

Note: The video above is a 3D animated demonstration illustrating the door lamp location, connector interface, and projection layout.

While the animation shows a flat-blade tool prying the housing, using a nylon or plastic trim pry tool on your vehicle helps prevent scuffs on the lower door paint or trim bezel. If you use a metal flat-blade screwdriver, wrap the tip in a layer of electrical tape first.

1
Pry Out the Factory Courtesy Lamp Assembly

Open the door and locate the rectangular courtesy lamp recessed into the bottom panel. Slide your plastic trim pry tool into the narrow gap along the retaining clip side of the housing and lever gently downward until the factory lamp drops free from the opening.

2
Unplug the Original Housing and Connect the STREK Module

Press the locking tab on the factory wiring harness plug (the vehicle-side electrical connector) and pull the stock lamp off. Align the keyed socket on the STREK LED puddle light with the factory plug and push firmly until the latch clicks into place. Do not pull on the wires when separating the connector.

3
Verify Projection Orientation and Snap Into Place

With the door open and interior courtesy circuit active, check the projected graphic on the ground to confirm right-side-up alignment. Once verified, tuck the excess harness slack back into the door cavity and press the module upward into the cutout until both end clips sit flush with the door trim.

Close-up view of the keyed socket on the STREK LED puddle light module aligning directly with the factory lower door wiring harness plug on an INEOS Grenadier without cutting or splicing wires.
Figure 3: Close-up view of the keyed factory door harness connector seating directly into the STREK LED module without wire splicing.

Recommended Compatible Hardware

Select the pattern matching your Station Wagon or Quartermaster build below, and choose quantity 2 if you want matching projection across all four doors.

STREK HARDWARE FOR THIS BUILD
STREK OFF ROAD · INEOS GRENADIER

LED Puddle Lights for INEOS Grenadier Station Wagon and Quartermaster

Qty: 2 PCS / Set · Fitment: 2023-2026 Station Wagon & Quartermaster · Install: Direct Plug-In (5-10 Min/Door)

Direct-fit lower door projection modules available in 7 vehicle-specific patterns (A-G) plus custom vector etching (H).

$149.00
2 PCS / Set · In Stock
View Pattern Options & Specifications →

Frequently Asked Questions

Q: How many puddle lights come in one set, and how many sets do I need for all four doors?

Each package includes 2 LED puddle light modules, which covers either the front pair or the rear pair of doors. Owners who want to replace all four lower door courtesy lamps on a Station Wagon or Quartermaster need to order 2 sets.

Q: Does this installation require cutting or splicing factory wires?

No wire cutting or splicing is required. The STREK module uses a direct factory-style connector that plugs straight into the existing door harness after you unplug the original lamp.

Q: Are the puddle light housings identical between the Station Wagon and the Quartermaster?

Both the 2023-2026 INEOS Grenadier Station Wagon and Quartermaster share the same lower door lamp opening and electrical connector. Patterns A through F display Grenadier graphics, while Pattern G features Quartermaster lettering.

Q: How does the Custom Pattern (Pattern H) ordering process work?

Select Pattern H at checkout and email your high-resolution vector artwork or logo along with your order number to sales@strekoffroad.com. Buyers remain responsible for intellectual property rights of submitted graphics.

Sources & Technical References
  • INEOS Automotive: Grenadier Station Wagon & Quartermaster Lower Door Courtesy Lamp Specifications (2023-2026).
  • STREK Off Road Product Documentation: INEOS Grenadier LED Puddle Lights (SKU Variants A-H & 3D Fitment Overview).
  • The INEOS Forum: Community technical discussions on interior and entry lighting upgrades.

Leave a Comment

Your email address will not be published.